There's nothing more frustrating than realizing – usually in the shower – that the kettle is no longer working. Sometimes it is detected when the faucet is turned on and only gets cold water, and other times it can be detected because of an unpleasant odor.
But even more disappointing than the lack of hot water is knowing that replacing the boiler is likely to be expensive – whether it's a whole tank or just a repair. Therefore, it is important to know some of the basic steps you need to take to minimize water repair. You can also take help from heater repair services in Longview to solve your problem.
- Make sure your kettle's temperature is no higher than 120 degrees Fahrenheit. A higher value not only means your electric bill will cost more, but the harder work means there will be more wear and tear on the different parts.
- Check the pressure relief valve at least twice a year to make sure it is not rusting. Early detection of leaks or corrosion means fewer problems in the future.
- Schedule a service visit at least once a year to make sure all parts and components are working properly
- Make sure there is adequate ventilation – especially with a gas heater! If ventilation is not working properly, your home can be attacked by toxic fumes.
- Twice a year, take the time to dry the boiler to remove sludge. Sludge buildup can cause a number of problems. You can drain the tank by first placing a 5-gallon bucket under the drain valve and then turning the valve counterclockwise to drain a few gallons of water into the bucket. Then close the valve and proceed as usual.